Specification about the Two Roll Mills!

The Two Roll Mill for Plastic Material has fixed friction and speed which is laid for continuous working conditions. This machine is also available with the roll diameters of about 150 mm.  These rolls are mainly driven by the geared AC Motor. This rear roll is usually driven by the spur gears for regular friction. The Modifications for the friction and speed are possible to meet the requirements of individual within specific steps.

The Two Roll Mill is aligned in the rigid frames. The rear roll is in the fixed position for great access to rolls. The front roll may be moved with the hand shaft. However, central adjustment confirms about parallel movement and working width is also laid for both the plastics processing as well as rubber processing.

The drive system of the Two Roll Mill Manufacturer is also equipped with the knee-actuated switch that is meant to stop the machine in an emergency. Moreover, opening to the essential safety distance may also be through hand though without turning the rear roll.

The rolls usually are made with the surface hardened and corrosion resistant steel. The system of central lubrication is well combined with high-temperature resistant and seal ring sickly low maintenance of the operation. The energy of electrical heating is offered by cartridges. Heat distribution is also well controlled in 3 diverse zones for equalizing difference over roll.

This machine is well equipped with the system of contractor control. The Roll temperature would also be controlled through the digital controllers. Through operating units which are mounted in the adjustable panel this machine may get operated from both the sides.

Electric system and the drive system are well incorporated in machine frame having simple access for the maintenance. This machine will get delivered with the integrated controls along with the connections of needs supply.